FIX A LEAK by Marlig pool LEAK SEALER 32oz/1L format treat up to 20000 gallons

Description

MONTRÉAL SPA DEPOT
Welcomes you !
Please visit my boutique for all Gecko Electronics, Balboa WG®, Aqua-Flo & Waterway Genuine original OEM warranty products needs for your spa, hot tub or bath tube
http://stores.cafr.ebay.ca/montrealspadepot
----------
This Ebay item is for one (1x) bottle of FIX-A-LEAK 32oz / 1L
for swimming pool, spas & hot tubs up to 20000 gallons / 76000 litres
(Picture showed both format of product, this item is for the big one.
see in my store for spa & hot tub 8oz  format )
GENERAL INFORMATION
FIX-A-LEAK
The only one....under the same leak conditions, FIX-A-LEAK will outperform the rest
Specializing in leak repair since 1980
FIX-A-LEAK
: is a blended concentrated material designed to seal leaks in virtually any material
: can be applied for leaks in the shell and works equally well in plumbing
: will seal holes 1/8" in diameter
: will form a permanent seal
Use 1 quart per pool up to 22,000 gallons.  Do not use in excess of 1 quart per 5,000 gallons of water.
DIRECTIONS
* Shake Well Before Using*
1.
Bypass FILTER MEDIA before adding
FIX-A-LEAK
to water.
Sand filters: set filter valve to recirculate.
Other types: remove cartridges DE elements from filter tank.  Then proceed to circulate through empty tank.
2.
With pump running, add
FIX-A-LEAK
slowly through skimmer or in front of any other suction intake.
3.
After adding
FIX-A-LEAK
adjust suction to main drain.  If this is not possible, the vacuum cleaner could be used
alternatively, simply by placing the vacuum in deepest part of pool and connect to normal vacuum connection.  Set filter
valve to normal vacuum position.
4.
FIX-A-LEAK
is very heavy and will sink to the lowest point rather quickly.  It must be stirred back into
suspension, either manually using a pool broom or mechnically with a automated pool cleaner every 4-6 hrs. during circulation of water.
5.
Continue to recirculate water until the leak has stopped.
6.
Mark level of water in pool and check for 2-3 days to determine if the leak has stopped.
7.
After the leak has stopped and given the proper time to cure (24-48 hrs.) you may return to normal filtration.
Sand Filters: Set filter valve to filter and resume normal operation.  Backwash out unused
FIX-A-LEAK
as required.
Other Types: Reinstall filter into tank and resume operation.  Rinse out unsed FIX-A-LEAK from filter as required.
*NOTE* Never let cartridges of DE elements be left to dry before they are cleaned.
8.
Treatment can be repeated if necessary.
*NOTE* Suction Line Leaks
Suction Leaks are usually known by air mixed with the water at the return fittings.
In most cases suction lines only leak water when the filter pump is shut off.
Normal Circulation will simply draw
FIX-A-LEAK
away from the leak and if the
pump is shut off the material will simply not get to the leak.  You must reverse the
flow of water, to force the material through the leak under pressure.  Preferably
5-10 psi. untill the leak has stopped.  When this has been achieved, gradually
increase pressure to 15-25 psi. to insure a proper seal.
VERY IMPORTANT:
After sealing a suction leak "it" is a must to leave suction
off the repaired line for no less than 48 hrs.
FIX-A-LEAK
requires time to cure and harden.
Miscellaneous Leaks:
If you suspect a leak around fittings inside the pool (such as return fittings) lights, skimmer(s)
or steps, etc.
Shut down pump.
Apply
FIX-A-LEAK
directly to the leak using a squeeze bottle, similar to a ketchup bottle.
Allow a minimum of 48 hrs. to cure before starting up circulation.
PRECAUTION: Keep Out Of Reach Of Children.
Can cause severe eye and skin irritation.  Do not get in eyes, on skin, or on clothing.
Harmful or fatal is swallowed.  Avoid contamination of food.
Rinse empty container thoroughly with water and discard it.
FIRST AID:
In case of contact, immediately flush eyes or skin with plenty of water for at
least 15 minutes.  For eyes, contact a physician.  Remove and wash contaminated clothing before
reuse.  If swallowed, drink milk, egg whites, gelatin solution.  If these are not available, drink large
quantities of water.  Call a physician immediately.
NOTE:
FIX-A-LEAK
has been thoroughly field-tested under various weather conditions, and
has proven to be effective in sealing leaks.
FIX-A-LEAK
is also an excellent preventative maintenance aid, as it coats all surfaces that it
comes in contact with, it cuts down on formation of rust and corrosion.
Marlig Industries nor its Agents assume responsibility for the performance of this material.
This Ebay item is for one (1x) bottle of FIX-A-LEAK 32oz / 1L
for swimming pool, spas & hot tubs up to 20000 gallons / 76000 litres
(Picture showed both format of product, this item is for the big one.
see in my store for spa & hot tub 8oz  format )
COMPLETE OEM PRODUCT FROM MARLIG INDUSTRIES INC. Brand new object.  Factory seal.
minimum selling retail price:  49.99$ + tx
MY PRICE:  37.99$ CAD
I do combined shipping for multiples & differents items
Real cost shipping rates (insured 100%) with shipping calculator 9" x 7" x 4" in. / 23 x 17 x 9 cm  Weight:  2.2lb./1.1kg
CANADA:  by CanadaPost
Expedited 1-7days
Standard 3-9days
Xpresspost 1-3 days, all trackables
USA:  CanadaPost&USPS
(1 bottle only) Airmail small packet USA 6-12days
no tracking#
Expedited parcel USA 4-10 days, with tracking#
INTERNATIONAL:
CanadaPost + your local Postal services
International Airmail small packet 6-15 days,
no tracking#
Trackable packet - International - EMS - 4-10 days, with tracking#